dahdi_test (8)

dahdi_test [ -v ]

dahdi_test dahdi_test runs a timing test in a loop and prints the result of each loop. The test is as follows:

It reads 8192 bytes from the DAHDI timer device (/dev/dahdi/pseudo). This should take exactly 8000 ms . It uses calls to gettimeofday(2) before and after that read to check that indeed exactly 8000ms have passed.

Values of 100% and 99.99% Are normally considered a definite pass. Values of 99.98% and 99.97% are probably OK as well.

-v

Be more verbose: print one line per test.

-c count

Run for count times instead of running forever.

/dev/dahdi/pseudo

The device file used to access the DAHDI timer.

dahdi_tool(8), dahdi_cfg(8), asterisk(8). gettimeofday(2)

This manual page was written by Tzafrir Cohen <[email protected]> Permission is granted to copy, distribute and/or modify this document under the terms of the GNU General Public License, Version 2 any later version published by the Free Software Foundation.