dahdi_cfg (8)

dahdi_cfg [-c CFG_FILE] [-SNUM [-SCHANS]] [-s] [-f] [-t] [-v [-v ... ] ]

dahdi_cfg -h

dahdi_cfg configures DAHDI interface cards from a config file.

You generally need to run it with a valid configurations in order for DAHDI modules to work properly.

It must be run to configure every DAHDI span. Normally it is run from the DAHDI init script.

-c CFG_FILE

Use an alternative configuration file instead of /etc/dahdi/system.conf

If CFG_FILE is '-', it is read from stdin.

-C CHANNELS

Only apply changes to channels in the specified range. Only applicable when -S is in use.

-s

Only shutdown spans.

-S SPAN

Only apply changes to span no. SPAN. For a digital span (with a 'span=' line in the configuration file) this will do. For an analog span you'll have to explicitly tell dahdi_cfg the range of channels, using -C .

-f

Always configure every channel, even if it appears not to have changed.

-t

Test mode. Don't do anything, just report what you wanted to do.

-v

Be more verbose. Add extra v-s for extra verbosity.

-h

Display a brief help message.

/etc/dahdi/system.conf

The default location for the configuration file.

dahdi_tool(8), dahdi_monitor(8), asterisk(8).

This manual page was written by Santiago Ruano Rinc\['o]n <[email protected]> for the Debian system (but may be used by others). Permission is granted to copy, distribute and/or modify this document under the terms of the GNU General Public License, Version 2 any later version published by the Free Software Foundation.