Configure marvell uap wireless driver
uaputl [options] <command> [parameters]
This manual page documents briefly the uaputl command, which is used to configure the device driver for Marvell's uAP wireless interface.
-d <debug_level>
Enable debugging output, level can be 0, 1, or 2.
-h, --help
Show summary of options and commands.
-i <interface>
Select interface to configure.
-v
Show version of program.
For more information on the usage of each command use:
uaputl.exe <command> --help
sys_config
Set/get uAP's profile
sys_info
Display system info
sys_reset
Reset uAP
bss_start
Start the BSS
bss_stop
Stop the BSS
sta_deauth
Deauth client
sta_list
Display list of clients
sys_cfg_ap_mac_address
Set/get uAP mac address
sys_cfg_ssid
Set/get uAP ssid
sys_cfg_beacon_period
Set/get uAP beacon period
sys_cfg_dtim_period
Set/get uAP dtim period
sys_cfg_channel
Set/get uAP radio channel
sys_cfg_scan_channels
Set/get uAP radio channel list
sys_cfg_rates
Set/get uAP rates
sys_cfg_rates_ext
Set/get uAP rates (extended)
sys_cfg_tx_power
Set/get uAP tx power
sys_cfg_bcast_ssid_ctl
Set/get uAP broadcast ssid
sys_cfg_preamble_ctl
Get uAP preamble
sys_cfg_antenna_ctl
Set/get uAP tx/rx antenna
sys_cfg_rts_threshold
Set/get uAP rts threshold
sys_cfg_frag_threshold
Set/get uAP frag threshold
sys_cfg_radio_ctl
Set/get uAP radio on/off
sys_cfg_tx_data_rate
Set/get uAP tx rate
sys_cfg_mcbc_data_rate
Set/get uAP MCBC rate
sys_cfg_rsn_replay_prot
Set/get RSN replay protection
sys_cfg_pkt_fwd_ctl
Set/get uAP packet forwarding
sys_cfg_sta_ageout_timer
Set/get station ageout timer
sys_cfg_auth
Set/get uAP authentication mode
sys_cfg_protocol
Set/get uAP security protocol
sys_cfg_wep_key
Set/get uAP wep key
sys_cfg_cipher
Set/get uAP WPA/WPA cipher
sys_cfg_wpa_passphrase
Set/get uAP WPA or WPA2 passphrase
sys_cfg_group_rekey_timer
Set/get uAP group re-key time
sys_cfg_max_sta_num
Set/get uAP max station number
sys_cfg_retry_limit
Set/get uAP retry limit number
sys_cfg_custom_ie
Set/get custom IE configuration
sta_filter_table
Set/get uAP mac filter
regrdwr
Read/Write register command
memaccess
Read/Write to a memory address command
rdeeprom
Read EEPROM
cfg_data
Get/Set configuration file from/to firmware
sys_debug
Set/Get debug parameter
sys_cfg_80211d
Set/Get 802.11D info
uap_stats
Get uAP stats
powermode
Set/get uAP power mode
coex_config
Set/get uAP BT coex configuration
This manual page was written by Bdale Garbee <[email protected]>, for the Debian project (and may be used by others).