tracereplay (1)

tracereplay [-b | -\^-broadcast] [-s -\^-snaplength [ snaplength] ] [-f | -\^-filter [ filter string ] ] inputuri outputuri

tracereplay replays inputuri to outputuri in trace time. Checksums are recomputed on the fly.

-b

-\^-broadcast

Change the 802.3 (ethernet) destination address to the broadcast address. This will send the transmitted packets to any hosts on the local network.

-s[snaplength]

-\^-snaplength[snaplength]

Truncate the packets to the length specified. This only makes a difference if the inputuri is a capture device. The value should be > 0. Inappropriate values will be ignored, but a warning will be printed.

-f[filterstring]

-\^-filter[filter]

Apply a filter to the inputuri.

More details about tracereplay (and libtrace) can be found at http://www.wand.net.nz/trac/libtrace/wiki/UserDocumentation

libtrace(3), tracesplit(1), tracesplit_dir(1), tracefilter(1), tracemerge(1), traceconvert(1), tracereport(1), tracertstats(1), tracestats(1), tracepktdump(1), traceanon(1), tracesummary(1), tracediff(1), traceends(1), tracetopends(1)

Andreas Loef <[email protected]>, Yuwei Wang <[email protected]>