trace-cmd-stack (1)

trace-cmd stack

The trace-cmd(1) stack enables the Ftrace stack tracer within the kernel. The stack tracer enables the function tracer and at each function call within the kernel, the stack is checked. When a new maximum usage stack is discovered, it is recorded.

When no option is used, the current stack is displayed.

To enable the stack tracer, use the option --start, and to disable the stack tracer, use the option --stop. The output will be the maximum stack found since the start was enabled.

Use --reset to reset the stack counter to zero.

trace-cmd(1), trace-cmd-record(1), trace-cmd-report(1), trace-cmd-start(1), trace-cmd-extract(1), trace-cmd-reset(1), trace-cmd-split(1), trace-cmd-list(1), trace-cmd-listen(1)

Written by Steven Rostedt, <\m[blue][email protected]\m[]\s-2\u[1]\d\s+2>

git://git.kernel.org/pub/scm/linux/kernel/git/rostedt/trace-cmd.git

Copyright (C) 2010 Red Hat, Inc. Free use of this software is granted under the terms of the GNU Public License (GPL).

1.

[email protected]

mailto:[email protected]