gnunet-gns (1)

gnunet-gns [options]

gnunet-gns can be used to lookup and process GNUnet Name Service names.

-c FILENAME, --config=FILENAME

Use the configuration file FILENAME.

-r, --raw

No unneeded output. This is a quiet mode where only important information is displayed. For example a lookup for an IP address will only yield the IP address, no descriptive text.

-h, --help

Print short help on options.

-L LOGLEVEL, --loglevel=LOGLEVEL

Use LOGLEVEL for logging. Valid values are DEBUG, INFO, WARNING and ERROR.

-u NAME, --lookup=NAME

Name to lookup. Resolve the specified name using the GNUnet Name System.

-p PKEY, --public-key=PKEY

Public key of the zone to perform the lookup in. This option should be used if the lookup is to be performed against a zone not controlled by this peer (alternatively, you could pass a ".zkey" for the name).

-T DELAY, --timeout=DELAY

Set the timeout to DELAY. By default, gnunet-gns will continue to try to resolve the name until there is a definitive answer or until the user aborts with CTRL-C.

-t TYPE, --type=TYPE

Resource Record Type (TYPE) to look for. Supported TYPE's are: A, AAAA, CNAME, NS, PKEY, PSEU, TLSA, SRV, SOA, MX, LEHO, VPN, REV, PTR, TXT

Defaults to "A".

-z NAME, --zone=NAME

Name of the ego of the zone to lookup the record in. The public key associated with the ego will be used for the zone.

-v, --version

Print GNUnet version number.

Report bugs by using Mantis <https://gnunet.org/bugs/> or by sending electronic mail to <[email protected]>

gnunet-namestore(1), gnunet-identity(1)