gnunet-arm (1)

gnunet-arm [options]

gnunet-arm can be used to start or stop GNUnet services, including the ARM service itself. The ARM service is a supervisor for GNUnet's service processes. ARM starts services on-demand or as configured and re-starts them if they crash.

-c FILENAME, --config=FILENAME

Use the configuration file FILENAME.

-e, --end

Shutdown all GNUnet services (including ARM itself). Running "gnunet-arm -e" is the usual way to shutdown a GNUnet peer.

-h, --help

Print short help on options.

-L LOGLEVEL, --loglevel=LOGLEVEL

Use LOGLEVEL for logging. Valid values are DEBUG, INFO, WARNING and ERROR.

-i SERVICE, --init=SERVICE

Starts the specified SERVICE if it is not already running. More specifically, this makes the service behave as if it were in the default services list.

-k SERVICE, --kill=SERVICE

Stop the specified SERVICE if it is running. While this will kill the service right now, the service may be restarted immediately if other services depend on it (service is then started 'on-demand'). If the service used to be a 'default' service, its default-service status will be revoked. If the service was not a default service, it will just be (temporarily) stopped, but could be re-started on-demand at any time.

-m, --monitor

Monitor service activity of ARM. In this mode, the command will not terminate until the user presses CTRL-C.

-s, --start

Start all GNUnet default services on this system (and also ARM). Naturally, if a service is demanded by a default service, it will then also be started. Running "gnunet-arm -s" is the usual way to start a GNUnet peer.

-I, --info

List all running services.

-v, --version

Print GNUnet version number.

Report bugs by using Mantis <https://gnunet.org/bugs/> or by sending electronic mail to <[email protected]>

gnunet-service-arm(1)