Upnp-av renderer daemon
gmediarender [options] files...
This manual page documents briefly the gmediarender command.
gmediarender is a daemon which acts as a UPNP-AV renderer on the local network. It can be controlled from a UPNP-AV control point to play media files from a UPNP-AV media server through an audio device on the local system.
This program follows the usual GNU command line syntax, with long options starting with two dashes (`-'). A summary of options is included below.
-d, --daemon
Runs the program as a daemon.
-f, --friendly-name lt;namegt;
Friendly name to advertise on the network.
Usually, it is desirable for the renderer to show up on controllers under a recognisable and unique name. This is the option to set that name.
-I, --ip-address lt;ip-addressgt;
The local IP address the service is running and advertised on.
This can only be a single address, and must be explicitly specified (i.e. not 0.0.0.0).
-p, --port lt;port>
Port to listen to. [49152..65535].
libupnp does not use SO_REUSEADDR, so it might be necessary to increment this number.
-P, --pid-file lt;pidfilegt;
Name of the file which the process ID should be written to.
-u, --uuid lt;uuid>
UUID to advertise on the network in the form user:group.
This sets the UPNP UUID that is advertised and used by controllers to distinguish different renderers. Usually, gmediarender uses a built-in static id. If there are multiple renderers running on the local network, they will all share the same static ID. With this option, each renderer can be given its own id. One way to generate a UUID is to create a UUID once by running the uuidgen tool.
--gstout-audiosink lt;sinkgt;
Set the audio sink.
--gstout-audiodevice lt;devicegt;
Set the audio device.
The --gstout-audio... options allow the user to configure where the sound output from gmediarender is sent. The correct values will depend on which method of audio output (e.g. ALSA) is being used.
--gstout-initial-volume-db lt;volumegt;
Sets the initial volume on startup in decibels.
Values range from 0 (maximum volume) to -60 (minimum volume. The decibel scale is non-linear: -20db represents roughly half volume. The default value is 0.
Note that this does not influence the hardware (e.g. ALSA) volume level, but only internal attenuation. It is advisable to set the hardware level to 100 where possible.
--list-outputs
List available output modules and exit.
-o, --output lt;modulegt;
Output module to use.
Use --output to obtain a list of valid modules.
--dump-devicedesc
Dump device descriptor XML and exit.
--dump-connmgr-scpd
Dump Connection Manager service description XML and exit.
--dump-control-scpd
Dump Rendering Control service description XML and exit.
--dump-transport-scpd
Dump A/V Transport service description XML and exit.
--logfile lt;logfilegt;
Name of a file to log output of the program to.
To log to the terminal use use --logfile \/dev\/stdout This file can get quite large over time, so it is only recommended to use this option for debugging purposes.
-h, --help
Show summary of options.
--help-all
Show all help options.
--help-gstout
Show GStreamer Output Options.
--help-gst
Show GStreamer Options.
-v, --version
Show the program version.