circuits.bench3 (1)

circuits.bench3 [options]

circuits.bench3 does some simple benchmaking of the circuits library.

-b address:[port]

Bind to address:[port] (UDP) to test remote events. Default address is 0.0.0.0.

-c integer

Set concurrency level to integer. Default is 1.

-d

Enable debug mode.

-e number

Stop after specified number of events. Default is 0.

-f number

number of dummy events to fill queue with. Default is 0.

-l

Listen on 0.0.0.0:8000 (UDP) to test remote events.

-m mode

Set operation mode. mode can be latency, speed or sync. Default mode is speed.

-o format

Specify output format. For example format can be:"cicuits.bench: events:%s, speed:%s, time:%s"

-p

Enable execution profiling support.

-q

Suppress output.

-s

Enable psyco (circuits on speed!) if it is available.

-t seconds

Stop after specified elapsed seconds.

-w

Wait for remote nodes to connect.

--version

Output version information and exit.

James Mills <[email protected]>

This manual page was written by Daniele Tricoli <[email protected]>, for the Debian project (but may be used by others).