ascii-xfr (1)

ascii-xfr -s|-r [-ednv] [-l linedelay] [-c characterdelay] filename

Ascii-xfr Transfers files in ASCII mode. This means no flow control, no checksumming and no file-name negotiation. It should only be used if the remote system doesn't understand anything else.

The ASCII protocol transfers files line-by-line. The EOL (End-Of-Line) character is transmitted as CRLF. When receiving, the CR character is stripped from the incoming file. The Control-Z (ASCII 26) character signals End-Of-File, if option -e is specified (unless you change it to Control-D (ASCII 4) with -d).

Ascii-xfr reads from stdin when receiving, and sends data on stdout when sending. Some form of input or output redirection to the modem device is thus needed when downloading or uploading, respectively.

-s

Send a file.

-r

Receive a file. One of -s or -r must be present.

-e

Send the End-Of-File character (Control-Z, ASCII 26 by default) when uploading has finished.

-d

Use the Control-D (ASCII 4) as End-Of-File character.

-n

Do not translate CR to CRLF and vice versa.

-v

Verbose: show transfer statistics on the stderr output.

-l milliseconds

When transmitting, pause for this delay after each line.

-c milliseconds

When transmitting, pause for this delay after each character.

file

Name of the file to send or receive. When receiving, any existing file by this name will be truncated.

If you want to call this program from minicom(1), start minicom and go to the Options menu. Select File transfer protocols. Add the following lines, for example as protocols I and J.

I  Ascii    /usr/bin/ascii-xfr -sv   Y   U   N   Y
J  Ascii    /usr/bin/ascii-xfr -rv   Y   D   N   Y

Miquel van Smoorenburg, [email protected]

Jukka Lahtinen, [email protected]

minicom(1)