/usr/local/sbin/ripd
The default location of the ripd binary.
ripd1
A rip routing engine for use with zebra
Usage
ripd [-dhrv]
[-f
config-file]
[-P
port-number]
Overview
ripd is a routing component that supports the zebra route engine. ripd supports RIPv1, RIPv2, and so forth.
Options
-
-d, --daemon -
Runs in daemon mode, forking and exiting from tty.
-
-f, --config-file config-file -
Specifies the config file to use for startup. If not specified this option will likely default to /usr/local/etc/ripd.conf.
-
-h, --help -
A brief message.
-
-P, --vty_port port-number -
Specify the port that the ripd VTY will listen on. This defaults to 2602, as specified in /etc/services.
-
-r, --retain -
When the program terminates, retain routes added by
ripd.
-
-v, --version -
Print the version and exit.
Commands
router rip rip version [1|2]
network [NETWORK] no network [NETWORK]
network [IFNAME] no network [IFNAME]
neighbor [IPADDRESS] no neighbor [IPADDRESS]
redistribute static no redistribute static
redistribute connected no redistribute connected
route [NETWORK] no route [NETWORK]
timers basic [UPDATE-INTERVAL] [INVALID] [HOLDDOWN] [FLUSH] no timers basic
ip rip send version [VERSION] ip rip receive version [VERSION]
distribute-list [ACCESS-LIST] [in|out] [IFNAME]
show ip rip show debugging rip
debug rip debug rip events debug rip packet debug rip zebra
Files
-
/usr/local/etc/ripd.conf -
The default location of the
ripdconfig file.
-
$(PWD)/ripd.log -
If the
ripdprocess is config'd to output logs to a file, then you will find this file in the directory where you startedripd.
Warning
This man page is intended as a quick reference for command line options, and for config file commands. The definitive document is the Info file zebra.
Diagnostics
The ripd process may log to standard output, to a VTY, to a log file, or through syslog to the system logs. ripd supports many debugging options, see the Info file, or the source for details.
Author[s]
See <www.zebra.org>, or the Info file for an accurate list of authors.