fsdb8

Usage

Overview

fsdb opens fsname (usually a raw disk partition) and runs a command loop allowing manipulation of the file system's inode data. You are prompted to enter a command with fsdb (inum X)> where X is the currently selected i-number. The initial selected inode is the root of the file system (i-number 2).

The command processor uses the editline(3) library, so you can use command line editing to reduce typing if desired. When you exit the command loop, the file system superblock is marked dirty and any buffered blocks are written to the file system.

The options are as follows:

-d

Enables additional debugging output (which comes primarily from fsck(8)-derived code).

-f fsname

Open file system fsname.

Besides the built-in editline(3) commands, fsdb supports these commands:

help

Print out the list of accepted commands.

inode i-number

Select inode i-number as the new current inode.

back

Revert to the previously current inode.

clri i-number

Clear the inode i-number.

lookup name, cd name

Find name in the current directory and make its inode the current inode. Name may be a multi-component name or may begin with slash to indicate that the root inode should be used to start the lookup. If some component along the pathname is not found, the last valid directory encountered is left as the active inode.

This command is valid only if the starting inode is a directory.

active, print

Print out the active inode.

uplink

Increment the active inode's link count.

downlink

Decrement the active inode's link count.

linkcount number

Set the active inode's link count to number.

ls

List the current inode's directory entries. This command is valid only if the current inode is a directory.

rm name, del name

Remove the entry name from the current directory inode. This command is valid only if the current inode is a directory.

ln ino name

Create a link to inode ino under the name name in the current directory inode. This command is valid only if the current inode is a directory.

chinum dirslot inum

Change the i-number in directory entry dirslot to inum.

chname dirslot name

Change the name in directory entry dirslot to name. This command cannot expand a directory entry. You can only rename an entry if the name will fit into the existing directory slot.

chtype type

Change the type of the current inode to type. type may be one of: file, dir, socket, or fifo.

chmod mode

Change the mode bits of the current inode to mode. You cannot change the file type with this subcommand; use chtype to do that.

chflags flags

Change the file flags of the current inode to flags.

chown uid

Change the owner of the current inode to uid.

chlen length

Change the length of the current inode to length.

chgrp gid

Change the group of the current inode to gid.

chgen gen

Change the generation number of the current inode to gen.

mtime time,

ctime time, atime time Change the modification, change, or access time (respectively) on the current inode to time. Time should be in the format YYYYMMDDHHMMSS[.nsec] where nsec is an optional nanosecond specification. If no nanoseconds are specified, the mtimensec, ctimensec, or atimensec field will be set to zero.

quit, q, exit, <EOF>

Exit the program.

Warning

Use this tool with extreme caution – you can damage an FFS file system beyond what fsck(8) can repair.