struct_nand_chip (9)

struct nand_chip {
  void __iomem * IO_ADDR_R;
  void __iomem * IO_ADDR_W;
  uint8_t (* read_byte) (struct mtd_info *mtd);
  u16 (* read_word) (struct mtd_info *mtd);
  void (* write_byte) (struct mtd_info *mtd, uint8_t byte);
  void (* write_buf) (struct mtd_info *mtd, const uint8_t *buf, int len);
  void (* read_buf) (struct mtd_info *mtd, uint8_t *buf, int len);
  void (* select_chip) (struct mtd_info *mtd, int chip);
  int (* block_bad) (struct mtd_info *mtd, loff_t ofs, int getchip);
  int (* block_markbad) (struct mtd_info *mtd, loff_t ofs);
  void (* cmd_ctrl) (struct mtd_info *mtd, int dat, unsigned int ctrl);
  int (* init_size) (struct mtd_info *mtd, struct nand_chip *this,u8 *id_data);
  int (* dev_ready) (struct mtd_info *mtd);
  void (* cmdfunc) (struct mtd_info *mtd, unsigned command, int column,int page_addr);
  int(* waitfunc) (struct mtd_info *mtd, struct nand_chip *this);
  int (* erase) (struct mtd_info *mtd, int page);
  int (* scan_bbt) (struct mtd_info *mtd);
  int (* errstat) (struct mtd_info *mtd, struct nand_chip *this, int state,int status, int page);
  int (* write_page) (struct mtd_info *mtd, struct nand_chip *chip,uint32_t offset, int data_len, const uint8_t *buf,int oob_required, int page, int cached, int raw);
  int (* onfi_set_features) (struct mtd_info *mtd, struct nand_chip *chip,int feature_addr, uint8_t *subfeature_para);
  int (* onfi_get_features) (struct mtd_info *mtd, struct nand_chip *chip,int feature_addr, uint8_t *subfeature_para);
  int (* setup_read_retry) (struct mtd_info *mtd, int retry_mode);
  int chip_delay;
  unsigned int options;
  unsigned int bbt_options;
  int page_shift;
  int phys_erase_shift;
  int bbt_erase_shift;
  int chip_shift;
  int numchips;
  uint64_t chipsize;
  int pagemask;
  int pagebuf;
  unsigned int pagebuf_bitflips;
  int subpagesize;
  uint8_t bits_per_cell;
  uint16_t ecc_strength_ds;
  uint16_t ecc_step_ds;
  int badblockpos;
  int badblockbits;
  int onfi_version;
  int jedec_version;
  union {unnamed_union};
  int read_retries;
  flstate_t state;
  uint8_t * oob_poi;
  struct nand_hw_control * controller;
  struct nand_ecc_ctrl ecc;
  struct nand_buffers * buffers;
  struct nand_hw_control hwcontrol;
  uint8_t * bbt;
  struct nand_bbt_descr * bbt_td;
  struct nand_bbt_descr * bbt_md;
  struct nand_bbt_descr * badblock_pattern;
  void * priv;
};

IO_ADDR_R

[BOARDSPECIFIC] address to read the 8 I/O lines of the flash device

IO_ADDR_W

[BOARDSPECIFIC] address to write the 8 I/O lines of the flash device.

read_byte

[REPLACEABLE] read one byte from the chip

read_word

[REPLACEABLE] read one word from the chip

write_byte

[REPLACEABLE] write a single byte to the chip on the low 8 I/O lines

write_buf

[REPLACEABLE] write data from the buffer to the chip

read_buf

[REPLACEABLE] read data from the chip into the buffer

select_chip

[REPLACEABLE] select chip nr

block_bad

[REPLACEABLE] check if a block is bad, using OOB markers

block_markbad

[REPLACEABLE] mark a block bad

cmd_ctrl

[BOARDSPECIFIC] hardwarespecific function for controlling ALE/CLE/nCE. Also used to write command and address

init_size

[BOARDSPECIFIC] hardwarespecific function for setting mtd->oobsize, mtd->writesize and so on. id_data contains the 8 bytes values of NAND_CMD_READID. Return with the bus width.

dev_ready

[BOARDSPECIFIC] hardwarespecific function for accessing device ready/busy line. If set to NULL no access to ready/busy is available and the ready/busy information is read from the chip status register.

cmdfunc

[REPLACEABLE] hardwarespecific function for writing commands to the chip.

waitfunc

[REPLACEABLE] hardwarespecific function for wait on ready.

erase

[REPLACEABLE] erase function

scan_bbt

[REPLACEABLE] function to scan bad block table

errstat

[OPTIONAL] hardware specific function to perform additional error status checks (determine if errors are correctable).

write_page

[REPLACEABLE] High-level page write function

onfi_set_features

[REPLACEABLE] set the features for ONFI nand

onfi_get_features

[REPLACEABLE] get the features for ONFI nand

setup_read_retry

[FLASHSPECIFIC] flash (vendor) specific function for setting the read-retry mode. Mostly needed for MLC NAND.

chip_delay

[BOARDSPECIFIC] chip dependent delay for transferring data from array to read regs (tR).

options

[BOARDSPECIFIC] various chip options. They can partly be set to inform nand_scan about special functionality. See the defines for further explanation.

bbt_options

[INTERN] bad block specific options. All options used here must come from bbm.h. By default, these options will be copied to the appropriate nand_bbt_descr's.

page_shift

[INTERN] number of address bits in a page (column address bits).

phys_erase_shift

[INTERN] number of address bits in a physical eraseblock

bbt_erase_shift

[INTERN] number of address bits in a bbt entry

chip_shift

[INTERN] number of address bits in one chip

numchips

[INTERN] number of physical chips

chipsize

[INTERN] the size of one chip for multichip arrays

pagemask

[INTERN] page number mask = number of (pages / chip) - 1

pagebuf

[INTERN] holds the pagenumber which is currently in data_buf.

pagebuf_bitflips

[INTERN] holds the bitflip count for the page which is currently in data_buf.

subpagesize

[INTERN] holds the subpagesize

bits_per_cell

[INTERN] number of bits per cell. i.e., 1 means SLC.

ecc_strength_ds

[INTERN] ECC correctability from the datasheet. Minimum amount of bit errors per ecc_step_ds guaranteed to be correctable. If unknown, set to zero.

ecc_step_ds

[INTERN] ECC step required by the ecc_strength_ds, also from the datasheet. It is the recommended ECC step size, if known; if unknown, set to zero.

badblockpos

[INTERN] position of the bad block marker in the oob area.

badblockbits

[INTERN] minimum number of set bits in a good block's bad block marker position; i.e., BBM == 11110111b is not bad when badblockbits == 7

onfi_version

[INTERN] holds the chip ONFI version (BCD encoded), non 0 if ONFI supported.

jedec_version

[INTERN] holds the chip JEDEC version (BCD encoded), non 0 if JEDEC supported.

{unnamed_union}

anonymous

read_retries

[INTERN] the number of read retry modes supported

state

[INTERN] the current state of the NAND device

oob_poi

"poison value buffer," used for laying out OOB data before writing

controller

[REPLACEABLE] a pointer to a hardware controller structure which is shared among multiple independent devices.

ecc

[BOARDSPECIFIC] ECC control structure

buffers

buffer structure for read/write

hwcontrol

platform-specific hardware control structure

bbt

[INTERN] bad block table pointer

bbt_td

[REPLACEABLE] bad block table descriptor for flash lookup.

bbt_md

[REPLACEABLE] bad block table mirror descriptor

badblock_pattern

[REPLACEABLE] bad block scan pattern used for initial bad block scan.

priv

[OPTIONAL] pointer to private chip data

Thomas Gleixner <[email protected]>

Author.