astribank_tool (8)

astribank_tool [ options ] [ operation... ] -D device-path

astribank_tool [-h]

astribank_tool is a tool to control the USB-level functionality of an Astribank. The tool operates on a single Astribank at a time (given as parameter to the -D command line option).

-D device-path

Required. The device to read from/write to. This is bus_num/device_num, where bus_num and device_num are the first two numbers in the output of lsusb(8) or dahdi_hardware(8). On older versions of this tool you needed a complete path to the device, which would be /dev/bus/usb/bus_num/device_num, or /proc/bus/usb/bus_num/device_num.

-p num

Set the TwinStar port number. Either 0 or 1.

(TODO: explain).

-r type

Reset the Astribank and renumerate its USB connection to power on product ID.

Tyep can be: half or full.

(TODO: explain those).

-w 0|1

Enable (1) or disable (0) the TwinStar watchdog. When enabled, the Astribank will jump to the second port if this system is "not working" and the system on the second port is available.

-Q

Query astribank properties via MPP protocol.

-n

Renumerate the Astribank product number (e.g: from 1161 to 1162).

-v

Increase verbosity. May be used multiple times.

-d mask

Set debug mask to mask. Default is 0, 0xFF is "everything".

-h

Displays usage message.

fxload(8), lsusb(8), astribank_hexload(8)

This manual page was written by Tzafrir Cohen <[email protected]> . Permission is granted to copy, distribute and/or modify this document under the terms of the GNU General Public License, Version 2 any later version published by the Free Software Foundation.

On Debian systems, the complete text of the GNU General Public License can be found in /usr/share/common-licenses/GPL.