input (5)

This manual page describes the output format of the file created by the Yagi-Uda project input or first programs. The file is an ASCII file, so can be edited manually if required. It is read by yagi or optimise. The program optimise also creates the same file format.

NOTES
FREQUENCY
MIN_FREQUENCY
MAX_FREQUENCY
STEP_FREQUENCY
ELEMENTS
DRIVEN
PARASITIC
ANGULAR_STEP
DATA_DRIVEN
DATA_PARASITIC

The
#
is used as a comment.

A typical file, for an antenna designed for the 2m amateur band (144-146
MHz) might be as shown below. Note:
1) Reflector is at position 0.0
2) All elements lengths/positions are in m.

NOTES This line can be up to 400 characters.
FREQUENCY 145.000000
MIN_FREQUENCY 144.000000
MAX_FREQUENCY 146.000000
STEP_FREQUENCY 0.100000
ELEMENTS 10
DRIVEN 1
PARASITIC 9
ANGULAR_STEP   180.000000
#DATA_DRIVEN x y length  diameter voltage phase
DATA_DRIVEN  0.30993 0.000000 1.002492 0.0063000000000000 1.000000 0.000000
# DATA_PARASITIC x y length  diameter
DATA_PARASITIC
   0.00000    0.00000    1.01902    0.00630
   0.49859    0.00000    0.95551    0.00630
   1.07338    0.00000    0.93595    0.00630
   1.81020    0.00000    0.92050    0.00630
   2.58152    0.00000    0.91322    0.00630
   3.30390    0.00000    0.91243    0.00630
   4.03692    0.00000    0.90423    0.00630
   4.64108    0.00000    0.89081    0.00630
   5.37418    0.00000    0.83912    0.00630

filename ASCII description of antenna. filename.out binary file

yagi(1), output(1), input(1), optimise(1), first(1) and yagi(5).

Dr. David Kirkby G8WRB ([email protected]), with help with converting to DOS from Dr. Joe Mack NA3T ([email protected]).