vcd2fst1
Converts vcd files to fst files
Usage
vcd2fst [option] ...
[VCDFILE]
[FSTFILE]
Overview
Converts VCD files to FST files.
Options
-
-v,--vcdname <filename> -
Specify VCD/FSDB/VPD/WLF input filename. Processing of filetypes other than VCD requires that the appropriate 2vcd converter was found during ./configure.
-
-f,--fstname <filename> -
Specify FST output filename.
-
-4,--fourpack -
Indicates that LZ4 should be used for value change data (default).
-
-F,--fastpack -
Indicates that fastlz should be used instead of LZ4 for value change data.
-
-Z,--zlibpack -
Indicates that zlib should be used instead of LZ4 for value change data.
-
-c,--compress -
Indicates that the entire file should be run through gzip on close. This results in much smaller files at the expense of a one-time decompression penalty on file open during reads.
-
-p,--parallel -
Indicates that parallel mode should be enabled. This spawns a worker thread to continue with FST block processing while conversion continues on the main thread for new FST block data.
-
-h,--help -
Show help screen.
- Note that you should specify dumpfile.vcd directly or use "-" for stdin.
Examples
- vcd2fst dumpfile.vcd dumpfile.fst --compress
-
This indicates that the FST file should be post-compressed on close.
Releases
9 releases since Debian 6.0 (Squeeze); the text changed 3 times.
--fourpack since Debian 8 (Jessie);
--parallel since Debian 7 (Wheezy);
--zlibpack since Debian 8 (Jessie);
-4 since Debian 8 (Jessie);
-Z since Debian 11 (Bullseye);
-p since Debian 7 (Wheezy).