uaputl1
Configure marvell uap wireless driver
Usage
uaputl [options]
<command>
[parameters]
Overview
This manual page documents briefly the uaputl command, which is used to configure the device driver for Marvell's uAP wireless interface.
Options
-
-d <debug_level> -
Enable debugging output, level can be 0, 1, or 2.
-
-h, --help -
Show summary of options and commands.
-
-i <interface> -
Select interface to configure.
-
-v -
Show version of program.
Commands
For more information on the usage of each command use:
uaputl.exe <command> --help
|
Set/get uAP's profile |
|---|---|
|
Display system info |
|
Reset uAP |
|
Start the BSS |
|
Stop the BSS |
|
Deauth client |
|
Display list of clients |
|
Set/get uAP mac address |
|
Set/get uAP ssid |
|
Set/get uAP beacon period |
|
Set/get uAP dtim period |
|
Set/get uAP radio channel |
|
Set/get uAP radio channel list |
|
Set/get uAP rates |
|
Set/get uAP rates (extended) |
|
Set/get uAP tx power |
|
Set/get uAP broadcast ssid |
|
Get uAP preamble |
|
Set/get uAP tx/rx antenna |
|
Set/get uAP rts threshold |
|
Set/get uAP frag threshold |
|
Set/get uAP radio on/off |
|
Set/get uAP tx rate |
|
Set/get uAP MCBC rate |
|
Set/get RSN replay protection |
|
Set/get uAP packet forwarding |
|
Set/get station ageout timer |
|
Set/get uAP authentication mode |
|
Set/get uAP security protocol |
|
Set/get uAP wep key |
|
Set/get uAP WPA/WPA cipher |
|
Set/get uAP WPA or WPA2 passphrase |
|
Set/get uAP group re-key time |
|
Set/get uAP max station number |
|
Set/get uAP retry limit number |
|
Set/get custom IE configuration |
|
Set/get uAP mac filter |
|
Read/Write register command |
|
Read/Write to a memory address command |
|
Read EEPROM |
|
Get/Set configuration file from/to firmware |
|
Set/Get debug parameter |
|
Set/Get 802.11D info |
|
Get uAP stats |
|
Set/get uAP power mode |
|
Set/get uAP BT coex configuration |
Releases
Unchanged in 7 releases since Debian 7 (Wheezy).