telepathy-haze8

Usage

Overview

Haze implements the Telepathy D-Bus specification using libpurple, allowing Telepathy clients like empathy(1) to connect to any protocol supported by pidgin(1).

It is a D-Bus service which runs on the session bus, and should usually be started automatically by D-Bus activation. However, it might be useful to start it manually for debugging.

Options

There are no command-line options.

Environment

HAZE_DEBUG=type

May be set to "all" for full debug output, or various undocumented options (which may change from release to release) to filter the output.

HAZE_PERSIST=1

If set, Haze will not automatically close itself after five seconds without any connections.

HAZE_LOGFILE=filename

If set, all debugging output will be written to filename rather than to the terminal.