scsi-spin8

Usage

Overview

scsi-spin let the user to manually spin up and down a SCSI device.

This command is particularly useful if you've got noisy (or hot) drives in a machine that you rarely need to access. This is not the same as the kernel patch that's floating around that will automatically spin down the drive after some time. scsi-spin is completely manual, and spinning down a drive that's in use, especially the one containing the scsi-spin binary, is probably a really bad idea.

To avoid running in trouble with such cases, scsi-spin verifies that the device to work on is not currently in use by scanning the mounted file system description file for a partition living on it and issue an error if this the case.

Options

-u, --up

spin up device.

-d, --down

spin down device.

-e, --loej

load or eject medium from drive (use along with -u or -d )

-w, --wait=[n]

wait up to n seconds for the spin up/down command to complete. Default is to return immediately after the command was sent to the device. Either repeat -w n times or set n to define the time to wait before to report a timeout.

-l, --lock

prevent removal of medium from device.

-L, --unlock

allow removal of medium from device.

-I, --oldioctl

use legacy ioctl interface instead of SG_IO to dialog with device (could not be supported on all platforms). -e and -w are not allowed with this option.

-v, --verbose=[n]

verbose mode. Either repeat -v or set n accordingly to increase verbosity. 1 is verbose, 2 is debug (dump SCSI commands and Sense buffer).

-f, --force

force spinning up/down the device even if it is in use.

-n, --noact

do nothing but check if the device is in use.

-p, --proc

use /proc/mounts instead of /etc/mtab to determine if the device is in use or not.

device

the device is any name in the filesystem which points to a SCSI block device (sd, scd) or generic SCSI device (sg). See section below.

SCSI devices naming convention