ne2k-diag8
Diagnostic program for ne2000 ethernet cards.
Usage
ne2k-diag [options]
Overview
ne2k-diag is used to diagnose detection ("probe") problems with NE1000 and NE2000 work-alike cards. The probe routine is very similar to that used in the Linux NE2000 driver, and should work with any NE2000 clone.
Options
These programs follow the usual GNU command line syntax, with long options starting with two dashes (`-'). A summary of options is included below.
-
-h, --help -
Show summary of options.
-
-V, --version -
Show version of program.
-
-v, --verbose -
Verbose mode.
-
-D -
Debug mode.
-
-a, --show-registers -
show chip status (use -aa for even more)
-
-e, --show-eeprom -
Dump EEPROM contents to stdout. (use -ee for even more)
-
-F, -X, --interface -
Valid values are 0-3.
-
-p, --base-address <port> -
Specify port to use.
-
-P, --new-address <address> -
Set card to a new hardware address.
-
-Q, --new-irq <irq> -
Set card to a new irq. Valid values are 2-5,7,9-15
-
-w -
Really write to EEPROM.
Releases
Unchanged in 5 releases since Debian 3.0 (Woody).