modconf8

Usage

Overview

modconf is a script for installing kernel modules on Linux. It can be used interactively (GUI mode) or from the command-line (batch mode).

Options

The options marked with a "*" below are applied only to one module. If you want to apply them to more than one module then repeat the option in the command line.

--source floppy|mounted

Indicates where the modules are to be obtained from. floppy is used when installing Linux. mounted is used on already installed Linux systems. This is the default.

--target directory

specifies where the etc/modules and etc/modules.conf are to be found on the system (default: / ). Do not include a trailing "/" after the directory name.

--libdir path

Indicates where the eval and descr.gz files are to be found on the system (default: /usr/share/modconf). Do not include a trailing "/" after the directory name.

--restrict-section section*

restricts modconf to only work with the specified section of /lib/modules

--exclude-section section*

force modconf to not work with the specified section of /lib/modules

Available sections at the time of this writing are: block cdrom fs ipv4 ipv6 misc net scsi (there may be others if you have installed packages with special modules, like pcmcia-modules).

--load-before module*

indicates a module that will be inserted before any others.

--load-only module*

specifies a module to be inserted after all those indicated with the --load-before option. Disables interactive mode.

--load-after module*

specifies a module to be inserted after all those indicated with the --load-before option.
This option is overridden by the previous one.

Examples

Examples below are untested

modconf --load-only plip --load-before ip_masq_ftp --load-only appletalk

Inserts modules "ip_masq_ftp", "plip" and "appletalk", in that order, and

does not run the interactive program.