malo4
Marvell libertas ieee 802.11b/g wireless network driver
Usage
To compile this driver into the kernel, place the following lines in your kernel configuration file:
device malo device pci device wlan device firmware
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
if_malo_load="YES"
Overview
The malo driver provides support for Marvell Libertas 88W8335 based PCI and Cardbus network adapters. malo supports station and monitor mode operation. Only one virtual interface may be configured at any time. For more information on configuring this device, see ifconfig(8).
This driver requires firmware to be loaded before it will work. The ports/net/malo-firmware-kmod port needs to be installed before ifconfig(8) will work.
Hardware
The following cards are among those supported by the malo driver:
| Netgear WG311v3 | 88W8335 | PCI | b/g |
| Tenda TWL542P | 88W8335 | PCI | b/g |
| U-Khan UW-2054i | 88W8335 | PCI | b/g |
Card Chip Bus Standard
Examples
Join an existing BSS network (i.e., connect to an access point):
ifconfig wlan create wlandev malo0 inet 192.168.0.20 \
netmask 0xffffff00
Join a specific BSS network with network name “my_net”:
ifconfig wlan create wlandev malo0 ssid my_net up
Join a specific BSS network with 64-bit WEP encryption:
ifconfig wlan create wlandev malo0 ssid my_net \ wepmode on wepkey 0x1234567890 weptxkey 1 up
Releases
43 releases since FreeBSD 7.1-RELEASE; the text changed 29 times.