fusioninventory-netdiscovery1p

Usage

Overview

fusioninventory-netdiscovery can be used to run a network discovery task without a GLPI server.

Options

--first ADDRESS

Set the first IP address of the network range to scan.

--last ADDRESS

Set the last IP address of the network range to scan.

--port PORT[,PORT2]

List of ports to try, defaults to: 161

Set it to 161,16100 to first try on default port and then on 16100.

--protocol PROTOCOL[,PROTOCOL2]

List of protocols to try, defaults to: udp/ipv4

Possible values are: udp/ipv4,udp/ipv6,tcp/ipv4,tcp/ipv6

--community STRING

Use given string as SNMP community (assume SNMPv1).

--credentials STRING

Use given string as SNMP credentials specification. This specification is a comma-separated list of key:value authentication parameters, such as:

•

version:2c,community:public

•

version:3,username:admin,authprotocol:sha,authpassword:s3cr3t

•

etc.

--timeout TIME

Set SNMP timeout, in seconds.

--entity ENTITY

Set GLPI entity.

--threads COUNT

Use given number of inventory threads.

--control

Output server-agent control messages, in addition to inventory result itself.

--debug

Turn the debug mode on. Multiple usage allowed, for additional verbosity.

Examples

Run a discovery against a network range, using SNMP version 1:

    $> fusioninventory-netdiscovery --first 192.168.0.1 --last 192.168.0.254 \
    --community public

Run a discovery against a network range, using multiple SNMP credentials:

    $> fusioninventory-netdiscovery --first 192.168.0.1 --last 192.168.0.254 \
    --credentials version:2c,community:public \
    --credentials version:3,username:admin,authprotocol:sha,authpassword:s3cr3t