fence_xcat8
I/o fencing agent for xcat environments
Usage
fence_xcat [OPTION] ...
Overview
fence_xcat is a wrapper to the rpower(1) command that is distributed with the xCAT project available at http://www.xcat.org. Use of fence_xcat requires that xcat has already been properly configured for your environment. Refer to xCAT(1) for more information on configuring xCAT.
fence_xcat accepts options on the command line as well as from stdin. fenced sends parameters through stdin when it execs the agent. fence_xcat can be run by itself with command line options which is useful for testing.
NOTE: It is recommended that fence_bladecenter(8) is used instead of fence_xcat if the bladecenter firmware supports telnet. This interface is much cleaner and easier to setup.
Vendor URL: http://www.xcat.org
Options
-
-h -
Print out a help message describing available options, then exit.
-
-n nodename -
The nodename as defined in nodelist.tab of the xCAT setup.
-
-o action -
The action required. on, off, reset (default) or stat.
-
-r rpower -
The path to the rpower binary.
-
-q -
Quiet mode: print only error messages.
-
-V -
Print out a version message, then exit.
Stdin parameters
agent = < param >
|
This option is used by fence_node(8) and is ignored by fence_xcat. |
|---|---|
nodename = < param >
|
The nodename as defined in nodelist.tab of the xCAT setup. |
action = < param >
|
The action required. on, off, reset (default) or stat. |
rpower = < param >
|
The path to the rpower binary. |
Releases
Unchanged in 3 releases since Debian 6.0 (Squeeze).