doas1
Execute commands as another user
Usage
doas [-Lns]
[-C
config]
[-u
user]
command
[args]
Overview
The doas utility executes the given command as another user. The command argument is mandatory unless -C, -L, or -s is specified.
The user will be required to authenticate by entering their password, unless configured otherwise.
By default, a new environment is created. The variables HOME, LOGNAME, PATH, SHELL, and USER and the umask(2) are set to values appropriate for the target user. DOAS_USER is set to the name of the user executing doas. The variables DISPLAY and TERM are inherited from the current environment. This behavior may be modified by the config file. The working directory is not changed.
The options are as follows:
-
-C config -
Parse and check the configuration file config, then exit. If command is supplied,
doaswill also perform command matching. In the latter case either ‘permit’, ‘permit nopass’ or ‘deny’ will be printed on standard output, depending on command matching results. No command is executed. -
-L -
Clear any persisted authentications from previous invocations, then immediately exit. No command is executed.
-
-n -
Non interactive mode, fail if the matching rule doesn't have the
nopassoption. -
-s -
Execute the shell from SHELL or /etc/passwd.
-
-u user -
Execute the command as user. The default is root.
Exit status
The doas utility exits 0 on success, and >0 if an error occurs. It may fail for one of the following reasons:
-
The config file /etc/doas.conf could not be parsed.
-
The user attempted to run a command which is not permitted.
-
The password was incorrect.
-
The specified command was not found or is not executable.
Releases
Unchanged in 4 releases since Debian 11 (Bullseye).