altera_jtag_uart(4freebsd)

altera_jtag_uart4freebsd

Driver for the altera jtag uart core

Usage

device altera_jtag_uart

In /boot/device.hints: hint.altera_jtag_uart.0.at="nexus0" hint.altera_jtag_uart.0.maddr=0x7f000000 hint.altera_jtag_uart.0.msize=0x40 hint.altera_jtag_uart.0.irq=0 hint.altera_jtag_uart.1.at="nexus0" hint.altera_jtag_uart.1.maddr=0x7f001000 hint.altera_jtag_uart.1.msize=0x40

Overview

The altera_jtag_uart device driver provides support for the Altera JTAG UART core, which allows multiple UART-like streams to be carried over JTAG. altera_jtag_uart allows JTAG UART streams to be attached to both the low-level console interface, used for direct kernel input and output, and the tty(4) layer, to be used with ttys(5) and login(1). Sequential Altera JTAG UART devices will appear as ttyu0, ttyu1, etc.

Hardware

Altera JTAG UART devices can be connected to using Altera's nios2-terminal program, with the instance selected using the --instance argument on the management host. altera_jtag_uart supports JTAG UART cores with or without interrupt lines connected; if the irq portion of the device.hints entry is omitted, the driver will poll rather than configure interrupts.

Releases

6 releases since Debian 8 (Jessie); the text changed 3 times.

  1. 8
  2. 9
  3. 10
  4. 11–13

History

The altera_jtag_uart device driver first appeared in FreeBSD 10.0.

Authors

The altera_jtag_uart device driver and this manual page were developed by SRI International and the University of Cambridge Computer Laboratory under DARPA/AFRL contract (FA8750-10-C-0237) (“CTSRD”), as part of the DARPA CRASH research programme. This device driver was written by Robert N. M. Watson.

Bugs

altera_jtag_uart must dynamically poll to detect when JTAG is present, in order to disable flow control in the event that there is no receiving endpoint. Otherwise, the boot may hang waiting for the JTAG client to be attached, and user processes attached to JTAG UART devices might block indefinitely. However, there is no way to flush the output buffer once JTAG is detected to have disappeared; this means that a small amount of stale output data will remain in the output buffer, being displayed by nios2-terminal when it is connected. Loss of JTAG will not generate a hang-up event, as that is rarely the desired behaviour.

nios2-terminal does not place the client-side TTY in raw mode, and so by default will not pass all control characters through to the UART.

From freebsd-manpages 12.2-2 in Debian 13 (Trixie). Parsed by carta from the page's mdoc source.